Brief Introduction of ACT MP48 ECU
ACT Mp48 ECU is a well-known, high -performance and reliable fuel conversion ECU.
Adopting high technology from Italy, Europe-imported chips to ensure the best quality among peer companies.
Mp48 ECU is disigned for 3/4 cylinder multipoin timed sequential injection engines. While runing on gas, Mp48 detec ts the pertrol injection time and pressure on the rail. It will calculate the equivalent amount of gas to be injected in the intake manifold to replicate the performance of the engine running on petrol. MP48 is equipped with a diagnosis system on every Gas component, whose status can be monitored by the calibration software during the installation of the system and at any time of the engine lifetime .The feature may prevent malfunctioning problems and makes technical interventions easier.
In addition, the calibration tool makes it simplified to install and set, and much cost is reduced.
MP48 is equipped with a 48-PIN connector, with IP54 high protection against water infiltration, it is easier for cable connection/ disconnection.
* Technical Parameters of ACT MP48 ECU:
Working voltage: 10~16V
Coil Resistance: over 0.5Ω
Injector Emulation Resistance: 150Ω
Ambient Temperature: -40~105 degrees
Waterproof Level: IP54 water Resistance
Connection: 48 Pins
ECU Kits ACT MP48 6124
Adopting high technology from Italy, Europe-imported chips to ensure the best quality among peer companies.
Mp48 ECU is disigned for 3/4 cylinder multipoin timed sequential injection engines. While runing on gas, Mp48 detec ts the pertrol injection time and pressure on the rail.